Aicaigou LogoAicaigou LogoB2B WikiIndustrial Encyclopedia

TPS22975NDSGR

Updated: 2026-07-15

Overview

The TPS22975NDSGR is a compact, high-efficiency load switch designed for modern electronic systems. It integrates advanced power management features to control power distribution in portable and embedded devices. This component is particularly valued for its ability to handle high currents with minimal voltage drop, thanks to its ultra-low on-resistance. Its small form factor makes it ideal for space-constrained applications.

Structure and Working Principle

TPS22975NDSGR 电源负载开关 TI 封装WSON(DSG)-8 批次NEW深圳市赛尔通科技有限公司

The TPS22975NDSGR consists of a MOSFET switch, control logic, and protection circuitry. It operates by receiving an enable signal to connect or disconnect the power source from the load. When enabled, the device gradually ramps up the output voltage to limit inrush current, protecting sensitive components downstream. The quick output discharge feature ensures rapid power-down when disabled.

商家经验真实案例 · 安全可信
丫1三极管参数
本文详细解析丫1三极管的关键参数,包括电流放大系数、最大集电极电流和耐压值等核心指标,帮助读者全面了解该器件的性能特点和应用场景。

Key Features

Ultra-low on-resistance (typically 20mΩ) minimizes power loss and heat generation during operation. The controlled turn-on feature prevents voltage spikes that could damage connected components. The device supports a wide input voltage range (1.2V to 5.5V) and can handle continuous currents up to 4A. Its thermal shutdown and overcurrent protection enhance system reliability.

Application Areas

This load switch is commonly found in smartphones, tablets, and wearable devices where efficient power management is critical. It's also used in IoT nodes and embedded systems for power domain isolation. Industrial applications include portable test equipment and distributed sensor networks where reliable power switching is required.

Maintenance and Precautions

TPS22975NDSGR 电源负载开关(路径管理) TI正品找润百信深圳市润百信科技有限公司

Ensure the maximum voltage and current ratings are not exceeded during operation. Proper PCB layout is crucial to maintain thermal performance - follow manufacturer guidelines for thermal vias and copper area. Avoid exposing the device to moisture or extreme temperatures beyond its specified operating range (-40°C to +85°C). ESD precautions should be observed during handling and installation.

商家经验真实案例 · 安全可信
三极管VB电压算法
本文解析三极管基极电压(VB)的计算方法,包括NPN和PNP型三极管的差异,以及实际电路中的典型应用场景和注意事项,帮助读者掌握关键参数的计算逻辑。

B2B Procurement Guide

When sourcing the TPS22975NDSGR, verify the manufacturer's part number and package type (DSBGA-6 in this case). Consider ordering samples for testing before large-volume purchases. Lead times typically range from 4-8 weeks for standard quantities. Some distributors may offer reel packaging for automated assembly. Compare pricing from authorized distributors as gray market components may lack reliability guarantees.

Related Manufacturers