Medium Temperature Fast Defoamer

Updated: 2026-08-06

Overview

Medium-Temperature Rapid Defoamer is a specialized chemical formulation designed to control foam in industrial processes operating between 40-80°C. Unlike high-temperature defoamers that degrade at moderate heat or cold-process variants that lose efficacy in warm conditions, this product bridges a critical performance gap. These defoamers typically combine polyether-modified silicones or mineral oil-based actives with emulsifiers for rapid dispersion. Their development responded to growing needs in bioprocessing and food-grade applications where extreme-temperature solutions were unsuitable.

Physical and Chemical Properties

The defoamer exhibits low viscosity (50-500 cP) for easy pumping and dispersion. Its surface tension (20-30 mN/m) enables quick penetration into foam lamellae. The formulation maintains stability across pH 3-11, making it versatile for acidic or alkaline systems. Key performance metrics include foam collapse time under 10 seconds and persistent activity for 4-8 hours per dose. Thermal stability testing confirms less than 5% efficacy loss after 100 hours at 70°C, outperforming conventional defoamers in this temperature range.

Main Applications

In wastewater treatment plants, it controls foam in aerated basins and digesters without harming microbial activity. Paper mills use it during pulp washing and coating processes to prevent defects. The food industry applies it in fermentation tanks and evaporators where USDA/FDA compliance is required. Emerging uses include 3D printing resin formulations and lithium battery electrolyte production. Unlike silicone-based defoamers that may cause craters in coatings, medium-temperature variants offer better compatibility with sensitive systems.

Safety and Storage

Most commercial products are classified as non-hazardous under GHS, though eye protection is recommended during handling. Storage tanks should be equipped with mild agitation to prevent separation. The shelf life is typically 12 months when stored in original sealed containers. Disposal follows standard chemical waste protocols. Incineration is preferred for concentrated waste, achieving over 99% mineralization. Environmental testing shows ready biodegradability (OECD 301F) for many formulations, reducing ecological impact.

B2B Procurement Guide

Industrial buyers should verify the defoamer's compatibility with their specific process temperature profile. Request technical datasheets with HLB (Hydrophile-Lipophile Balance) values - optimal ranges are 3-5 for oil systems and 8-12 for aqueous applications. For large-volume procurement (>1 ton), consider customized formulations that match your system's ionic strength and shear conditions. Bulk shipments in IBC totes (1000L) typically offer 15-20% cost savings versus drum quantities. Always audit suppliers for ISO 9001 and relevant industry certifications (e.g., NSF for food contact).