Double-sided Galvanized Coil

Updated: 2026-07-25

Overview

Double-sided galvanized steel coil is produced by continuous hot-dip galvanizing, where steel substrate is coated with molten zinc on both sides. This process creates a metallurgical bond, offering superior protection against rust compared to electroplating. The product is standardized under ASTM A653 (USA), EN 10346 (Europe), and JIS G3302 (Japan), with variations in coating thickness (e.g., 20–180 g/m² per side). Common base materials include low-carbon steels (e.g., DX51D, DX52D) for formability or high-strength steels (e.g., HSLA grades) for structural applications. The zinc coating may feature regular spangle, minimized spangle, or zero-spangle finishes, depending on aesthetic and functional requirements.

Physical and Chemical Properties

The zinc coating (typically 99.5% pure) forms a barrier against moisture and oxygen, while also providing cathodic protection to exposed steel edges. Coating adhesion is tested via bend or impact tests per ASTM D3359. The base steel retains its mechanical properties (e.g., tensile strength: 270–550 MPa, elongation: 22–45%), allowing for stamping, bending, and roll-forming. Galvanized coils exhibit excellent weather resistance, with salt spray test results typically exceeding 500 hours to red rust (ASTM B117). The natural formation of zinc carbonate patina further enhances durability in outdoor environments. Thermal stability is limited to ~200°C to prevent zinc-iron intermetallic brittleness.

Main Applications

Construction accounts for ~60% of usage, including roofing sheets, wall cladding, and steel framing (e.g., Light Gauge Steel structures). In automotive manufacturing, galvanized coils are used for underbody panels, fuel tanks, and structural components, leveraging their corrosion-welding balance. Appliance manufacturers utilize galvanized steel for washing machine drums, refrigerator cabinets, and air conditioner housings due to its hygienic surface and paint adhesion. Industrial applications include cable trays, grain silos, and electrical enclosures. Post-painted or laminated variants expand design possibilities for architectural projects.

Safety and Storage

Galvanized steel poses minimal health risks during handling, but welding or cutting requires local exhaust ventilation to prevent metal fume fever from zinc oxide inhalation. OSHA PEL for zinc oxide fumes is 5 mg/m³ (8-hour TWA). Storage should avoid condensation (stack coils with spacers) and direct ground contact. Indoor storage is ideal; outdoor storage requires waterproof covering with breathable materials to prevent white rust (wet storage stain). Chromate passivation or oiling enhances temporary protection during transit.

B2B Procurement Guide

Key specifications to confirm: coating designation (e.g., Z120 = 120 g/m² total zinc), surface finish (e.g., regular spangle for aesthetics, smooth for painting), and width tolerances (typically ±2 mm). Mill certifications should include chemical composition, mechanical properties, and coating weight test reports. Lead times vary from 2–8 weeks depending on custom requirements (e.g., non-standard widths, skin-pass rolling). MOQs range from 20–50 tons for standard grades. Consider coil weight (usually 3–15 tons) and inner/outer diameter (e.g., 508/610 mm) for logistics compatibility. Third-party inspection (SGS/BV) is recommended for international shipments.