Aicaigou LogoB2B WikiIndustrial Encyclopedia

BT169D SCR

Updated: 2026-08-05

Overview

The BT169D is a sensitive gate silicon-controlled rectifier designed for low-current switching applications. As a member of the BT169 series, it offers reliable performance in AC phase control circuits and small power switching applications. With its compact TO-92 package, this SCR is widely used in consumer electronics, lighting controls, and small appliance circuits. Its sensitive gate characteristic allows triggering with minimal current, making it suitable for microcontroller interfaces.

Structure and Working Principle

BT169D 单向可控硅 微触发晶闸管 TO-92封装 600V赛米微尔 原装赛米微尔半导体(上海)有限公司

The BT169D consists of four alternating P-type and N-type semiconductor layers (PNPN structure) with an anode, cathode, and gate terminal. When a small current is applied to the gate (typically 5-15mA), the device switches to its conducting state. In operation, the SCR remains non-conducting until triggered by the gate signal, after which it continues conducting until the current drops below the holding current threshold (typically 5-10mA for the BT169D). This latching behavior makes it ideal for power control applications.

商家经验真实案例 · 安全可信
D2822A芯片代换指南
本文针对D2822A芯片损坏后的替代方案进行详细解析,包括直接兼容型号、功能相近替代方案以及更换时的注意事项,帮助工程师快速找到解决方案。

Key Features

The BT169D stands out for its sensitive gate requirement (IGT typically 0.2mA), allowing direct interfacing with logic circuits. It has a repetitive peak off-state voltage (VDRM) of 400V and average on-state current (ITAV) of 0.8A. Other notable characteristics include low holding current, fast switching capability, and high noise immunity. The TO-92 package offers good thermal performance for its current rating while maintaining a compact footprint suitable for space-constrained designs.

Application Areas

Primary applications include small appliance controls, lighting dimmers, and low-power motor speed controls. It's commonly found in coffee makers, electric blankets, and similar household devices. In industrial settings, the BT169D serves in sensor interfaces, small relay drivers, and low-power AC switching circuits. Its reliability and cost-effectiveness make it popular for OEM designs requiring simple, robust power control solutions.

Maintenance and Precautions

BT169D 集成电路(IC) 原厂封装 稳定性好 湿度敏感性高深圳市新思汇科技有限公司

When using the BT169D, ensure operating parameters stay within specified limits (particularly voltage and current ratings). Proper heat dissipation should be maintained, especially in enclosed spaces or high ambient temperatures. Circuit design should include protection against voltage transients, typically with snubber networks. Avoid static discharge during handling, and consider using anti-static precautions during assembly to prevent gate oxide damage.

商家经验真实案例 · 安全可信
CS4398芯片发热解析
本文探讨CS4398这款电压型DAC芯片的发热特性,分析其工作温度表现及影响因素,帮助读者了解该芯片在实际应用中的热管理要点。

B2B Procurement Guide

When sourcing BT169D SCRs, verify manufacturer specifications match your requirements, as parameters can vary slightly between brands. Consider ordering from authorized distributors to ensure authentic components. For volume purchases (1,000+ units), prices typically range from $0.10 to $0.25 per unit. Lead times vary but are generally 4-8 weeks for large orders. Always request sample units for testing before major purchases to confirm performance in your application.

Related Manufacturers