Aicaigou LogoAicaigou LogoB2B WikiIndustrial Encyclopedia

AT45DB321D-SU

Updated: 2026-08-02

Overview

The AT45DB321D-SU is a high-performance Flash memory chip manufactured by Adesto Technologies. It provides 32Mbit (4MB) of non-volatile storage with a serial peripheral interface (SPI), making it suitable for embedded systems requiring reliable data storage. This chip is widely used in industrial, automotive, and consumer electronics due to its low power consumption, high-speed read/write operations, and robust design. Its flexible architecture allows for both page and sector erase operations, enabling efficient memory management.

Structure and Working Principle

AT45DB321D-SUXPB 电子元器件 ATMEL 封装SOP8 批次24+深圳市新思汇科技有限公司

The AT45DB321D-SU is built on a silicon-based Flash memory architecture, organized into 8,192 pages of 528 bytes each. It supports SPI modes 0 and 3, ensuring compatibility with a wide range of microcontrollers and processors. The chip operates on a supply voltage of 2.7V to 3.6V, making it suitable for low-power applications. Data retention is guaranteed for up to 20 years, and the device can endure 100,000 write cycles per sector, ensuring long-term reliability.

商家经验真实案例 · 安全可信
解调器商贸解析
本文深入探讨解调器在工业采购中的应用场景和关键作用,分析其技术特点与商贸流通中的注意事项,为B2B采购提供实用参考。

Key Features

The AT45DB321D-SU stands out for its 32Mbit storage capacity and efficient serial interface, which simplifies integration into existing systems. Its flexible erase capabilities (page, block, or full chip) provide versatility for various applications. Additional features include a deep power-down mode for minimal energy consumption when idle and a built-in security register for protecting sensitive data. These attributes make it a preferred choice for applications requiring reliable and scalable memory solutions.

Application Areas

This Flash memory chip is commonly used in industrial automation, automotive systems, medical devices, and consumer electronics. Its reliability and endurance make it ideal for firmware storage, data logging, and configuration settings. In industrial settings, the AT45DB321D-SU is often employed in programmable logic controllers (PLCs) and sensors. In consumer electronics, it can be found in smart home devices and wearable technology, where compact and efficient memory solutions are critical.

Maintenance and Precautions

AT45DB321D-SUXPB 电子元器件 ATMEL 封装8-SOIC 批次24+深圳市新思汇科技有限公司

To ensure optimal performance, the AT45DB321D-SU should be handled with proper electrostatic discharge (ESD) protection. Avoid exposing the chip to excessive heat or moisture, as these conditions can degrade its performance and longevity. Regular firmware updates and memory health checks are recommended to maintain data integrity. When designing circuits, ensure that the voltage levels and signal timings comply with the chip's specifications to prevent operational issues.

商家经验真实案例 · 安全可信
2000w衰减器
本文介绍2000w衰减器的主要特点和应用场景,包括其功率处理能力、信号衰减原理以及在不同电子设备中的实际应用,帮助读者全面了解这一电子元件。

B2B Procurement Guide

When procuring the AT45DB321D-SU, verify the supplier's authenticity to avoid counterfeit products. Reputable distributors and direct purchases from manufacturers are preferred. Consider bulk purchasing for cost savings, but ensure proper storage conditions to prevent damage. Lead times can vary, so plan orders in advance, especially for large quantities. Always check for compliance with industry standards and certifications relevant to your application.

Related Manufacturers